Bernina 56 User Manual page 30

56-82e_EN_ES_FR_PT_230807:07_55-90e_EN_ES_FR_PT.qxd
56 66
23.8.2007
82e
16:12 Seite 32
Attaching the presser foot
GB EN
holder
Attention:
Turn power switch to "O" before carrying
out any of the operations below.
Raise the needle to its highest position and
raise the presser foot lever. Attach the
presser foot holder (b) to the presser foot
bar (a). (1) Tighten the fixation screw. (A)
Attaching the presser foot:
Lower the presser foot holder (b) until the
cut-out (c) is directly above the pin (d). (2)
Lower the presser foot holder (b) and the
presser foot (f) will engage automatically.
Removing the presser foot:
Raise the presser foot.
Release the pressure foot by raising lever
(e) located at the back of the foot
holder. (3)
Attaching the seam guide:
Attach the seam guide (g) in the slot as
illustrated. Adjust the distance as required
for hems, pleats, etc....(4)