BMW 5251 Service Manual page 603

Gearshift
Linkage
-
Connect selector rod to shift lever. Lift transmission, install
crossmember and tighten crossmember bolts.
Install driveshaft and heat shield. See
260 Driveshaft.
Reinstall exhaust system. See 180 Exhaust System.
.
Lower vehicle. Install shift boot. Push shift ltnob
on
lever.
Tightening torque
Driveshaft
CV
joint to final drive flange
.
M I 0 (Tom bolt)
70 Nm (51 ft-lb)
.
M8 (compression nut) 32 Nm (24 ft-lb)
-
Driveshaft clamping sleeve
-
M I 0 ribbed nuts 80 Nm (59 ft-lb)
M I 0 compressed nuts 64 Nm (47 ft-lb)
Flex-disc to driveshaft or transmission flange
MlO (8.8 grade) 48 Nm (35 ft-lb)
.
M I 0 (10.9 grade)
60 Nm (44 ft-lb)
-
M I 2 (10.9 grade)
100 Nm (74 ft-ib)
M I 4 140 Nm (103 fi-lb)
Transmission crossmember
.
to transmission 21 Nm (15 ft-lb)
.
to chassis 42 Nm (30 ft-lb)