Gearshift Lever, Removing (Manual Transmission) - BMW 5251 Service Manual

Gearshift ~inkaael
Gearshift lever, removing
(manual transmission)
Use the accompanying illustration as a guide when removing
and installing the gearshift linkage.
-
Remove shift knob by pulling knob straight off shift lever.
NOTE-
Pull up on the shift knob with about
90
lbs. of force. Do not
twist knob or locating key can be damaged.
-
Squeeze sides of shift boot to unclip from center console.
Pull boot up and off shift lever.
-
Remove sound insulation at base of shift lever.
-
Raise vehicle to gain access to underside of vehicle.
- - -
WARNING-
Male sure the car is stable and well supported at all tfmes.
Use a professional automotwe hft orjaclc stands designed for
the purpose. A floorjaclc 1 s not adequate support.
-
Remove complete exhaust system. See 180 Exhaust
System.
-
Remove driveshaft. See 260 Driveshaft.
-
Support transmission with transmission jack. Remove
crossmember from rear of transmission.
-
Lower rear of transmission to access gearshift linkage.
CA UTIOI\C
Tilting the engine to lower the transmission can lead to
damage to various components due to lack of clearance.
4
Working above transmission, disconnect selector rod:
* Pull off shift rod retaining circlip (A).
Remove washer ( 6 ) .
Disengage selector rod (C) from gearshift lever.