Checlc flywheel location dowel
and correct installation.
sleeve (arrow) for damage
4
When installing dual-mass flywheel, position dowel sleeve
next to two locating notches (arrows).
-
Install flywheel using new self-locking bolts,
Tightening torque
Flywheel to cranltshaft
(use new self-locking bolts)
120
Nm
(89
ft-lb)
Use new self-lock~ng bolls lo rnslall llylvheel Do not reuse llle
old slrelch-lype bolls Do nor rnsrall bolls wrlh Loct~lo@ or srm-
I
ilar thread licking compound.
1
Flywheel, removing and installing
(V-8
engine)
-
Inspect flywheel for scoring, hot spots, cracks or loose or
worn guide pins. Replace flywheel if any faults are found.
4
Loclcflywheel with BMW special tool 11 2 070. Remove pres-
sure plate and clutch disc as described earlier.
-
Use BMW special tool 11 4 180 (Ton.
T60)
to loosen and re-
move flywheel mounting bolts. Remove flywheel.
-
Clean flywheel bolt threads in crankshaft