Clutch Slave Cylinder. Replacing - BMW 5251 Service Manual

21 0-8
Clutch
4
Remove hydraulic line locking clip (1) and pull line (2) off
master cylinder.
CAUTION-
.
To prevent brake fluidspill, wrap clutch master cylinder with
shop rags when removing hydraulic fluid lines from master
cylinder.
* Brake fluid damages paint andstains carpets. Clean off
any brake fluid on or in the car immediately.
-
Remove master cylinder with supply hose
4
Remove switch module from master cylinder.
Press locking button (A) to release harness connector.
Pull harness connector (8) off switch module.
Use screwdriver to lever off switch module (C).
-
Installation is reverse of removal.
CA UTlON-
Switch module must snap firmly into place on the master cyl-
inder during installation.
Tightening
torques
Clutch master cylinder to pedal cluster
10
Nm (89 in-lb)
Fluid line
to
master cylinder or slave cylinder 17
Nm
(13
ft-lb)
-
Fill fluid reservoir with clean fluid. Bleed clutch hydraulics as
described earlier.
Clutch slave cylinder, replacing
4
Working inside engine compartment, remove left interiorven-
tilation filter housing:
Release 3 plastic taps (A) on duct. Early models: release
latch.
Rotate duct inward to remove.
Disconnect electrical harness to hood position switch.
Release spring lock (B) on interior ventilation housing and
remove housing.
-
Pinch off brake fluid supply hose to clutch master cylinder us-
ing BMW special tool 13 3 01 0 or equivalent hose clamping
tool.