Starter. Removing And Installing (V-8 Engine) - BMW 5251 Service Manual

Battery, Starter, ~lternatorl
-
Disconnect wiring from starter.
4
Note routing for cables. Routing varies depending on model
and transmission. When reinstalling, make sure cables do
not chafe.
-
Using a long extension and universal joint from output end of
transmission, remove bolts fastening starter to transmission
bell housing and engine block.
-
Remove starter from below
4
Checlc starter pinion gear and flywheel teeth for damage.
-
Installation is reverse of removal.
Tightening torques
Starter
to
engine
47 Nrn (35
It-lb)
Starter sipport bracket to starter
5 Nrn (44
in-lb)
Starter support bracket to engine
47 Nrn (35
ft-lb)
Wlre terminals
to
slarter
M5 5 Nrn (44
in-lb)
M6 7 Nrn (62
in-lb)
M8 13 Nrn (10
ft-lb)
Starter, removing and installing
(V-8 engine)
The starter is on the right (passenger) side of the engine, and
is removed from below. Access to starter bolts is difficult. Be
sure to have the proper tools on hand before proceeding.
-
Disconnect negative (-) battery cable
CA UTIOW-
Prior to disconnecting the battery, read the battev discon-
nection cautions in OOlGeneral Cautions and Warnings.
-
-
Raise vehicle and support safely.
/
WARNING-
1
~ ~~ ~~ ~~~ ~
Make sure the car is stable and well supported at all times.
Use a professional automotive lift orjacltstands designed for
I
the purpose. A floor jack is not adequate support
I