Door Window. Removing And Installing - BMW 5251 Service Manual

512-9
Door
Windows
Vertical adjustment
-
Adjustments are made with window in open position
4
Loosen window clamping fasteners (arrows), but do not
remove.
Adjust rear clamp and tighten fastener.
Tighten front clamp fastener.
4
Raise door window up to stop:
Check gap (A) at window front edge,
Checlc gap (5) at window top edge.
NOJE-
Measure window frame between door window edge and
panel.
Front window gap settings
Front of window (A)
5.4
mm (0.21 in)
Top of window (6)
10 mm (0.39 in)
Tightening torque
Window regulator guide rail to door
10 Nm (89 in-lb)
Door window, removing and installing
-
Remove door panel as described in 411 Doors
-
Reconnect window switch and lower window down to conve-
nient height and disconnect window switch.
-
Disconnect negative (-) cable from battery, then remove air-
bag unit and vapor barrier from door. See 721 Airbag Sys-
tem (SRS).
WARNING
-
Prior to disconnecting the battery, read the battery discon-
nection cautions given in 001 General Warnings and
Cautions.