Sunroof Panel Gasket, Replacing (Steel Or Glass) - BMW 5251 Service Manual

Sunroof
4
Remove three Torx screws (arrows) on each side, and lift
panel out.
-
Installation is reverse of removal. Adjust sunroof height and
gap as described earlier. See Sunroof, adjusting.
Tightening torques
Wind blocker to roof (Torx)
1 Nm (9
in-lb)
Sunroof panel to roof (Torx)
6
Nm
(4.4 ft-lb)
Sunroof panel gasket, replacing
(steel or glass)
-
Remove sunroof panei. See Sunroof panei, removing and
installing (steel o r glass).
Pull old seal from panel.
Coat new seal and channel in sunroof panel with soapy
water.
* Starting at back center of panel, install new seal, taking
care to not pull seal too tightly around four corners of
panel.
-
Installation is reverse of removal. Adjust sunroof height and
gap as shown earlier in this repair group. See Sunroof, ad-
justing.
Tightening torques
Wind bloclter to roof (Torx)
Sunroof panel to roof (Torx)
1 Nm
(9 in-lb)
6 Nrn
(4.4 ft-lb)