BMW 5251 Service Manual page 577

230-1
3
Manual ~ransmissionl
I 4
Remove shims under collar nut and set aside.
-
Use puller to remove output flange
4
Use BMW special tool 00 5 010 or other suitable seal puller
to remove seal from transmission housing.
4
Coat new seal with transmission fluid. Use seal installation
drift, BMW special tool 23 2 480 or equivalent, to drive seal
into housing as far as it will go.
-
Inspect sealing surface on output flange. Replace if worn or
damaged.
-
Coat sealing lip of seal, sealing surface of output flange and
transmission splined shaft with transmission oil.
4
Press output flange on output shafl using BMW special tool
23 3 010.
.
Counterhold flange with BMW special tool 23 0 020.
Tighten special tool 23 2 010 to 200 Nm (148 ft-lb).
Remove special tools.