I
Rear Suspension
4
Press out axle shaft using BMW special tools 33
2
117. 33 2
116and332111.
4
Remove upper front control arm (traction strut) ball joint
mounting nut (arrow). Press control arm ball joint out of
wheel bearing carrier.
-
Repeat above process on upper rear control arm.
-
Remove wheel bearing carrier assembly.
4
When reinstalling, pull axle shafl through wheel bearing car-
rier using BMW special tools 33
2
115, 33 2 116 and 33 2
118.
-
Lightly oil bearing surface of axle collar nut and install. Tight-
en collar nut firmly, but do not fully tighten it at this time.
WARNING-
For safety reasons, the axle collar nut should only be tight-
ened to its final torque with the wheel installed and the car
lowered to the ground. However, loading the bearing without
the nut tiqhtened suificiently may darnaqe the bearina.