BMW 5251 Service Manual page 222

11 6-46
/cylinder Head and Valvetrain
I I
Camshafts, installing, right cylinder head (M62 engine)
I
1
A : \
/
Camshafts are marked at rear. Install camshafts into cam-
shaft bearing saddles of cylinder heads.
Intake camshaft for right cylinder head ( 1 4 ) is labelled
E 1-4.
Exhaust camshaft for right cylinder head (1-4) is labelled
A 1-4.
4
Rotate camshafts so that recesses in Intake and exhaust
camshafts polnt upward 30 to 40' above seal~ng surface for
valve cover (arrows).
4
Bearing caps are marked with a code for location.
NOTE-
The camshaft caps are stamped with a code letter
-
"E" for
the intake side and
'N"
for the exhaust side. Number code is
forposition on head, with number 7 being the front bearing
cap.
CAUTION--
Do not mix up camshafi bearing caps between cylinder
banks.