Replacing The Drum Light Bulb; Replacing The Drum Light Housing; Replacing The Drum Light Socket; Replacing The Felt Seal - Electrolux 6000 Service Manual

Replacing the drum light bulb:

1. Open the dryer door, release the clip holding the
light shield by pushing up, and unscrew the 7 watt
incandescent bulb.

Replacing the drum light housing:

1. Disconnect the dryer from electrical supply.
2. Remove the top, lean the top of the front panel
forward and disconnect the wires from the light
socket.
3. Push in to release the tab at the end of the housing
and push the housing into the drum.

Replacing the drum light socket:

1. Disconnect the dryer from electrical supply.
2. Remove the top and disconnect the wires from the
light socket.
3. Remove the light bulb, squeeze the tabs on the side
of the socket and push the socket into the housing.

Replacing the felt seal:

1. Disconnect the dryer from electrical supply.
2. Remove the front panel.
3. The felt seal, a (2) piece seal that is glued to the front
panel rim, is what the drum rides on.
4. To replace the seal, pull the old seal off and glue the
replacement to the rim.

Replacing the foam seal:

1. Disconnect the dryer from electrical supply.
2. Remove the front panel.
72