Removing The Burner (Gas Dryers); Removing The Ignitor (Gas Dryers); Removing The Gas Valve Assembly (Gas Dryers) - Electrolux 6000 Service Manual

4. Release the front motor lock from the blower
housing.
5. Release the spring clip holding down on the rear of
the motor and lift the motor out.
Spring
Clip
Removing the burner: (Gas dryers)
1. Disconnect the dryer from electrical supply and
remove the front panel.
2. Unplug the igniter, remove the (2) screws holding
the burner to the valve assembly bracket, and slide
the burner into the combustion chamber to release
burner from the valve.
Removing the ignitor: (Gas dryers)
1. Disconnect the dryer from electrical supply and
unplug the igniter harness.
2. The igniter is held to the burner mounting bracket by
a screw and a tab. Remove the screw and lift the
igniter up to release the tab, then slide the igniter
forward.
Removing the gas valve assembly: (Gas
dryers)
1. Turn the gas supply off and disconnect the dryer
from electrical supply.
2. Unplug the wires from the valves.
78