Removing The Rear Access Panel; Releasing The Dryer Belt; Removing The Vane From The Drum; Removing The Drum - Electrolux 6000 Service Manual

3. The foam seal, glued to front panel duct, provides a
seal between the front panel duct and the blower.
4. To replace the seal, pull the old seal off and glue the
replacement to the duct.

Removing the rear access panel:

1. Remove the (2) screws holding the access panel
to the rear panel and swing the left side of the panel
out to disengage the tabs.

Releasing the dryer belt:

1. Remove the access panel.
2. Push the idler pulley to the right and slip the belt off
the motor pulley.

Removing the vane from the drum:

1. Disconnect the dryer from electrical supply.
2. Open the door, remove the top panel, remove the (2)
screws holding the vane to the drum and drop the
vane into the drum.

Removing the drum:

1. Disconnect the dryer from electrical supply.
2. Remove the top and the front panels.
3. Release the belt from the motor.
73