Replacing The Sensor Bars; Replacing The Front Panel Air Duct - Electrolux 6000 Service Manual

4. Pull out on the bottom of the front panel to release
the spring loaded tabs.
5. Lift up on the front panel to release the (2) tabs at the
top, one on each end, and swing the panel out.
6. Disconnect the wiring from the drum light, door
switch, the ground wire, and unplug the wiring
harness from the sensor bars.

Replacing the sensor bars:

1. Disconnect the dryer from electrical supply.
2. Open the dryer door and remove the lint screen.
3. Remove the (2) screws holding the vent grill to the
front panel.
4. Pull the grill into the drum and disconnect the wires.

Replacing the front panel air duct:

1. Disconnect the dryer from electrical supply and
remove the front panel.
2. Remove the (2) screws holding the vent grill to the
front panel.
3. Release the sensor wire harness and pull down to
remove the air duct.
71