Electrolux 6000 Service Manual page 20

are packed in the dryer for the installer's reference. Refer
to INSTALLATION INSTRUCTIONS for detailed grounding
procedures. If the dryer is moved to a new location, have
it checked and reinstalled by a qualified service
person.
To prevent personal injury or damage to
the dryer, the electrical power cord of a gas dryer must
be plugged into a properly grounded and polarized 3-
prong outlet. The third grounding prong must never
be removed. Never ground the dryer to a gas pipe.
Do not use an extension cord or an adaptor plug.
ALWAYS disconnect the dryer from the
electrical supply before attempting any service or clean-
ing. Failure to do so can result in electrical shock or
injury.
Do not use any type spray cleanser
when cleaning dryer interior. Hazardous fumes or elec-
trical shock could occur.
To prevent injury, do not reach into the
dryer if the drum is moving. Wait until the dryer has
stopped completely before reaching into the drum.
To prevent injury and damage to the
dryer:
• All repairs and servicing must be performed by
an authorized servicer unless specifically
recommended in this Owner's Guide. Use only
authorized factory parts.
• Do not tamper with controls.
• Do not install or store the dryer where it will be
exposed to the weather.
A thermal limiter switch automatically turns off the
motor in the unlikely event of an overheated situation
(electric dryers only). A service technician must replace
the thermal limiter switch after correcting the fault.
Failure to comply with these warnings could result
in serious personal injuries.
Avoid fire hazard or electrical shock. Do
not use an adaptor plug or extension cord or remove
grounding prong from electrical power cord. Failure to
follow this warning can cause serious injury, fire or death.
ELECTRIC DRYERS:
14-30R
FUSED 30 AMP
120/240 V OR
120/208 V
WALL
RECEPTACLE
CORRECT
Use this way ONLY
Grounding type
wall receptacle
cord with three prongs
CORRECT Use this way ONLY
Note: The instructions appearing in this Owner's Guide
are not meant to cover every possible condition and
situation that may occur. Common sense and caution
must be practiced when installing, operating and
maintaining any appliance.
20
DRYER
DRYER
S E R V I C E
CORD
GAS DRYERS
Do not under
any circumstances
cut, remove,
or bypass
the grounding prong
from this plug.
Power supply
grounding plug