All Gas Dryer; Electrical Connections For 3-Wire System Non Canadian Electric Dryers; Electrical Connections For 4-Wire System Non Canadian Electric Dryers - Electrolux 6000 Service Manual

1. The dryer must be grounded. In the event of a
malfunction or breakdown, grounding will reduce the
risk of electrical shock by a path of least resistance
for electrical current.
2. Since your dryer is equipped with a power supply
cord having an equipment-grounding conductor and
a grounding plug, the plug must be plugged into an
appropriate outlet that is properly installed and
grounded in accordance with all local codes and
ordinances. If in doubt, call a licensed electrician.
Do not modify plug provided with the appliance.
ALL GAS Dryers
This dryer is equipped with a three-prong (grounding plug
for your protection against shock hazard and should be
plugged directly into a properly grounded three-prong
receptacle. Do not cut or remove the grounding prong
from this plug.
ELECTRICAL CONNECTIONS FOR 3-WIRE SYSTEM
NON-CANADIAN ELECTRIC Dryer
1. Remove the screws securing the terminal block
access cover and the strain relief mounting bracket
located on the back of the dryer upper corner.
2. Install a U.L. approved strain relief into the power cord
entry hole of the mounting bracket. Finger tighten
the nut only at this time.
3. Thread a U.L. approved 30 amp. power cord, NEMA
10-30 type SRDT, through the strain relief.
4. Attach the power cord neutral (center wire) conductor
to the silver colored center terminal on the terminal
block. Tighten the screw securely.
5. Attach the remaining two power cord outer conductors
to the outer brass colored terminals on the terminal
block. Tighten both screws securely.
Do not make a sharp bend or crimp
wiring/conductor at connections.
6. Reattach the strain relief mounting bracket to the back
of the dryer with two screws. Tighten screws
securely.
7. Tighten the screws securing the cord restraint firmly
against the power cord.
8. Tighten the strain relief nut securely so that the strain
relief does not turn.
9. Reinstall the terminal block cover.
GREEN
GROUND
SCREW
GREEN
NEUTRAL
GROUND
WIRE
This dryer is equipped with a three-prong (grounding)
plug for your protection against shock hazard and should
be plugged directly into a properly grounded three-prong
receptacle. Do not cut or remove the grounding prong
from this plug.
ELECTRICAL CONNECTIONS FOR 4-WIRE SYSTEM
NON-CANADIAN ELECTRIC Dryer
1. Remove the screws securing the terminal block
access cover and the strain relief mounting bracket
located on the back of the dryer upper corner.
2. Install a U.L. approved strain relief in the entry hole of
the mounting bracket. Finger tighten the nut only at
this time.
37
SILVER TERMINAL
NUT
TIGHTENNUT
TO THESE
THREADS
STRAIN
RELIEF
MOUNTING
BRACKET
POWERCORD