Cli: Viewing And Configuring Authorized Ip Managers - HP Q.11.XX Manual

Using Authorized IP Managers
Defining Authorized Management Stations
Applies only to access through Telnet, SNMPv1,
and SNMPv2c. Refer to the Note on page 10-3.
Figure 10-2. Example of How To Add an Authorized Manager Entry (Continued)
10-6
Editing or Deleting an Authorized Manager Entry. Go to the IP Manag-
ers List screen (figure 10-1), highlight the desired entry, and press
(for Delete).
or [D]

CLI: Viewing and Configuring Authorized IP Managers

Authorized IP Managers Commands Used in This Section
Command
show ip authorized-managers
ip authorized-managers
<ip-address>
<ip-mask-bits>
[access <operator | manager>]
Listing the Switch's Current Authorized IP Manager(s)
Use the show ip authorized-managers command to list IP stations authorized to
access the switch. For example:
2. Enter an Authorized Manager IP address here.
3. Use the default mask to allow access by one
management device, or edit the mask to allow
access by a block of management devices. See
"Building IP Masks" on page 10-9.
4. Use the Space bar to select Manager or Operator
access.
5. Press [Enter], then [S] (for Save) to configure the
IP Authorized Manager entry.
Page
below
10-7
10-8
10-8
(for Edit)
[E]