Configuring Tacacs+ On The Switch; Before You Begin - HP Q.11.XX Manual

TACACS+ Authentication

Configuring TACACS+ on the Switch

4-8
check the configuration in your TACACS+ server application for mis-
configurations or missing data that could affect the server's interopera-
tion with the switch.
8. After your testing shows that Telnet access using the TACACS+ server is
working properly, configure your TACACS+ server application for
console access. Then test the console access. If access problems occur,
check for and correct any problems in the switch configuration, and then
test console access again. If problems persist, check your TACACS+
server application for mis-configurations or missing data that could
affect the console access.
9. When you are confident that TACACS+ access through Telnet/SSH and
the switch's console operates properly, use the write memory command
to save the switch's running-config file to flash memory.

Configuring TACACS+ on the Switch

Before You Begin

If you are new to TACACS+ authentication, ProCurve recommends that you
read the "General Authentication Setup Procedure" on page 4-5 and configure
your TACACS+ server(s) before configuring authentication on the switch.
The switch offers three command areas for TACACS+ operation:
show authentication and show tacacs: Displays the switch's TACACS+
■
configuration and status.
aaa authentication: A command for configuring the switch's authenti-
■
cation methods
tacacs-server: A command for configuring the switch's contact with
■
TACACS+ servers