Configuring Radius Accounting - HP Q.11.XX Manual

Procurve 2510 series switches
Table of Contents

Advertisement

Note

Configuring RADIUS Accounting

RADIUS Accounting Commands
[no] radius-server host < ip-address >
[acct-port < port-number >]
[key < key-string >]
[no] aaa accounting < exec | network | system >
< start-stop | stop-only> radius
[no] aaa accounting update
periodic < 1 - 525600 > (in minutes)
[no] aaa accounting suppress null-username
show accounting
show accounting sessions
show radius accounting
This section assumes you have already:
Configured RADIUS authentication on the switch for one or more
access methods
Configured one or more RADIUS servers to support the switch
If you have not already done so, refer to "General RADIUS Setup Procedure"
on page 5-5 before continuing here.
RADIUS accounting collects data about user activity and system events and
sends it to a RADIUS server when specified events occur on the switch, such
as a logoff or a reboot. The switch supports three types of accounting services:
Network accounting: Provides records containing the information
listed below on clients directly connected to the switch and operating
under Port-Based Access Control (802.1X):
• Acct-Session-Id
• Acct-Status-Type
• Acct-Terminate-Cause
• Acct-Authentic
• Acct-Delay-Time
• Acct-Input-Packets
RADIUS Authentication, Authorization and Accounting

Configuring RADIUS Accounting

Page
5-28
5-28
5-28
5-31
5-31
5-31
5-36
5-37
5-36
• Acct-Output-Packets
• Acct-Input-Octets
• Nas-Port
• Acct-Output-Octets
• Acct-Session-Time
• Username
• Service-Type
• NAS-IP-Address
• NAS-Identifier
• Called-Station-Id
5-25

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

U.11.xxProcurve 2510-24Procurve 2510-48

Table of Contents