Minimum Thrust, Analog Thruster; Speed Source - Simrad AP50 Installation Manual

Simrad AP50 Autopilot
SEATRIAL
Thruster zero 00%
Maximum thrust STBD 080%
Maximum thrust PORT 079%
Minimum thrust 00%
No
Yes
U
+10V
(100%)
30%
SEATRIAL
Minimum thrust
P S
00
Adjust?
SEATRIAL
Minimum thrust
P S
25
25
Adjust?
SEATRIAL
Compass Flux1
Calibration
Offset +005°
Heading 288°

Speed source

Man
Set cruising speed --kt
66

Minimum Thrust, Analog Thruster

(ONLY IF CONTINUOUS THRUSTER OR DANFOSS
THRUSTER IS SELECTED)
The Minimum thrust determines the amount of power (in % of
the maximum control signal) that is applied as the "first
command signal".
The example shows 30% of the control signal
applied as Minimum thrust.
The dotted line shows the output signal for
Minimum
Minimum thrust set to 0.
thrust OFF
Range:
Default: 0%.
Heading error
Rotate the course knob clockwise to activate the Minimum
thrust setting.
Rotate the course knob to port or starboard to find the minimum
amount of thrust you must apply as "first command signal".
Proceed to the Speed source item by pressing the
button or return to STANDBY mode by pressing the
button.
Speed source
Select the Speed source setting. Refer to Interface Set-up table
on page 58. If no speed source is available, set the Speed source
to Man and proceed to the Set cruising speed item by pressing
the (STBD) button or return to STANDBY mode by pressing
the (STBY) button.
S TB Y
0-50% in step of 1%.
(STBD)
(STBY)
S TB Y
20222469 / B