Fu50 Steering Lever; Ti51 Thruster Interface; Ad50 Analog Drive; S9 Steering Lever - Simrad AP50 Installation Manual

2.13 FU50 Steering Lever

2.14 TI51 Thruster Interface

2.15 AD50 Analog Drive

2.16 S9 Steering Lever

20222469 / B
RFC35
FLUXGATE
COMPASS
Figure 2-28 RFC35 connection
• Change in the Installation Interface menu: Select FLUX =
J50-HS.
For connection of the FU50 Steering Lever, see the FU50
manual.
The TI51 Thruster Interface is designed to provide control signal
for operating one thruster in an AP50 system by either on/off
solenoid, continuous control, or Sauer Danfoss PVEM valve.
Refer to separate manual for the TI51 Thruster Interface.
The AD50 Analog Drive is designed to provide analog or
proportional control of a rudder in an AP50 system by either
continuous voltage, or Danfoss PVEM valve signal.
Refer to separate manual for the AD50 Analog Drive.

Mounting

Refer to Figure 2-29. For bulkhead mounting, use the 8 bushings
enclosed with the unit. These are placed two and two against
each other and the screws are put through them. Direct contact
between S9 and a steel bulkhead is then avoided and corrosion is
prevented. The cover plate can be turned 360 degrees for the
most convenient position of cable outlet. For panel mounting
use the two mounting brackets enclosed with the unit (Figure
2-30).
JUNCTION UNIT
MAIN PCB
Heading
Sensor
*
* NON POLARIZED
(COLOR INDEPENDENT)
Installation
33