Js10 Joystick; S35 Nfu Lever Installation; Interfacing - Simrad AP25 Instruction Manual

Simrad AP25 Autopilot

3.11 JS10 Joystick

Refer to separate installation instructions supplied with the JS10
Joystick.

3.12 S35 NFU Lever installation

The unit is mounted to a bulkhead or panel by two screws from
the front. The cable is connected to the autopilot computer
according to Figure 3-11. Interchange the Port and Stbd wires to
the screw terminals if necessary to make the direction of the
lever movement coincide with the direction of the rudder
movement.
STEERING LEVER
The unit is opened by removing the three screws on the back
cover. Inside are two sets of micro-switches, a printed circuit
board with a plug-in terminal and a jumper strap.

3.13 Interfacing

With the AP25 autopilot system there are several possibilities to
connect to other equipment for data collection and exchange.
1. Use SimNet
2. Use SimNet via AT10 Universal SimNet/NMEA Converter
3. Connect to a NMEA2000 network via the adapter (drop)
60
S35
Figure 3-11 S35 connection
cable, part no. 24005729.
AUTOPILOT COMPUTER
TB1 TB2 NFU
4
1
20222139A