Using The Port To Port Function - Yamaha QL5 Reference Manual

6
DELAY button
Switches the output port delay on or off.
7
Ø (Phase) button
Switches the phase of the signal assigned to the output port between normal phase
(black) and reverse phase (yellow).
8
GAIN knob
Adjusts the output gain of the output port. To adjust this value, press the knob on screen
to select it, and then operate the [TOUCH AND TURN] knob. Rotate the knob to set the
value in 1.0 dB steps. Rotate the knob while pressing and holding it down to set the
value in 0.1 dB steps. The current value appears immediately below the knob.
9
Level meter
Indicates the level of the signal assigned to the output port.
0
Tabs
Switch the output ports controlled in groups of up to eight ports. Tabs are categorized
into three groups: DANTE, SLOT, and PATCH VIEW. To display tabs in the desired group,
press the group name button located at the right or left end of the bottom row.

Using the PORT TO PORT function

STEP
1. In the Function Access Area, press the SETUP button.
2. Press the OUTPUT PORT button in the SYSTEM SETUP field located in the center of the
SETUP screen.
3. Press the channel select button in the OUTPUT PORT screen.
4. In the CH SELECT screen, select the output port.
HA AD
HA AD
SLOT
SLOT
Dante
Use the PORT TO PORT function to output from an input jack on the rear panel to a Dante
connector without sending the signal through the mixer. This allows you to use the I/O jacks
on QL series consoles as I/O jacks for an audio network.
47
INPUT
INPUT
DA
OUTPUT
DA
OUTPUT
SLOT
SLOT
Dante
OUTPUT channels
Reference Manual