Yamaha QL5 Reference Manual page 130

I/O DEVICE screen (Rio page)
1 2
1
Display switch buttons
Press one of these buttons to view the corresponding I/O device. If you press and hold
down this button, all LEDs of the corresponding I/O device will blink.
For more information about VIRTUAL/CONFLICT/DUPLICATE displayed below this
1
button, refer to on page 127, "I/O device
2
ID/Model name display
This shows the ID number, model name, and version of the I/O device.
3
DANTE SETUP button
Press this button to open the DANTE SETUP window, in which you can make settings
for the audio network.
3
list."
 HA display
This shows the HA settings of the I/O device. Press this area to open the I/O DEVICE HA
window, in which you can make detailed head amp settings.
6
5
4
7
4
Analog GAIN knob
Indicates the analog gain setting. This screen is only for display; the value cannot be
edited.
5
+48V indicator
Indicates the phantom power (+48V) on/off status for each port.
6
OVER indicator
Warns you when the input signal is clipping.
7
HPF indicator
Indicates the high-pass filter on or off status for each port.
 INPUT display
This shows the input settings of the I/O device.
If you press the [SEL] key of an input channel, the corresponding port will light. (It does not
light for external QL series consoles.)
 OUTPUT display
This shows the output settings of the I/O device. Press here to access the OUTPUT PATCH
window, where you can make output port settings for the I/O device.
If you press the [SEL] key of an output channel, the corresponding port will light. (It does not
light for external QL series consoles.)
130
I/O devices and external head amps
Reference Manual