Setting The Date And Time Of The Internal Clock; Setting The Network Address - Yamaha QL5 Reference Manual

5
SCREEN
Adjusts the brightness of the touch screen.
If the brightness is set to lower than level 2, the QL will start up next time with a
brightness setting of 2 so that you will be able to see the screen.
6
PANEL
Adjusts the brightness of the top panel LEDs.
NOTE
If the AD8HR is connected, the brightness of the AD8HR's LEDs will also change.
7
LAMP
Adjusts the brightness of the lamps connected to the rear panel LAMP jacks.

Setting the date and time of the internal clock

This section explains how to set the date and time of the QL console's internal clock, and how
to select the date and time display format. The date and time you specify here will affect the
time stamp used when saving a scene.
STEP
1. In the Function Access Area, press the SETUP button.
2. Press the DATE/TIME button at the lower part of the SETUP screen.
3. In the FORMAT field of the DATE/TIME window, press the MODE buttons several
times to select the desired format for date and time display.
4. Use the [TOUCH AND TURN] knob to set the current date and time.
5. When you have finished making settings, press the OK button.
DATE/TIME window
Press the DATE/TIME button in the SETUP screen to open this window.
1 2
1
DATE
Specifies the date of the internal clock.
2
TIME
Specifies the time of the internal clock.
3
3
FORMAT (Display format)
Specifies the format in which the date and time of the internal clock are displayed.
You can select from the following display formats.
• Date
MM/DD/YYYY (Month/Day/Year)
DD/MM/YYYY (Day/Month/Year)
YYYY/MM/DD (Year/Month/Day)
• Time
24-Hour (hours shown in the range of 0–23)
12-Hour (hours shown from 0am–11am, and 0pm–11pm)

Setting the network address

This section explains how to set the network address that will be required when you use the
NETWORK connector on the QL series console to connect it to a computer.
If you plan to connect the QL series console to your computer in a one-to-one connection, we
recommend that you use the following default values. Make sure that the IP address and
Gateway address do not match the addresses of any other device on the network.
IP Address: 192.168.0.128 or similar
Gateway address: 192.168.0.1 or similar
Subnet mask: 255.255.255.0 or similar
NOTE
• Only the Administrator can change network settings.
• For details on settings related to connecting to a LAN, refer to the QL Editor Installation Guide.
STEP
1. In the Function Access Area, press the SETUP button.
2. Press the NETWORK button at the lower part of the SETUP screen.
3. Press and select the knobs in the NETWORK window to specify the address using the
[TOUCH AND TURN] knob.
4. When you have finished making settings, press the OK button.
5. Restart the QL series console.
191
Setup
Reference Manual