Yamaha QL5 Reference Manual page 65

CH LINK MODE window
You can view the channels that are linked and specify the parameters that will be linked.
1
2
3
4
1
Channel display field
When you create a link group, the corresponding channels will be highlighted. If there
are two or more link groups, each group is shown in a different color. Press this field to
open the CH LINK SET window. You can also link channels in this window.
NOTE
• Left and right of the ST IN channel are always linked.
• In the case of the QL1, faders that do not exist on the model will not be shown.
2
Link indicator
If a channel belonging to a link group is selected, the associated link group is shown.
The LINK PARAMETER field and SEND PARAMETER field show the link settings.
While you hold down the [SEL] key of a channel that does not belong to any link group,
the link indicator shows the link group that will be created next. The LINK PARAMETER
field and SEND PARAMETER field show the settings of the link group that had been
previously displayed.
3
LINK PARAMETER field
Use the buttons in this field to select the parameters that you want to link. You can do
this independently for each link group.
The table below lists the parameters you can select in the LINK PARAMETER field.
HA Head amp settings
HPF
HPF settings
DIGITAL GAIN Digital gain settings
EQ EQ settings
DYNAMICS 1, 2 Dynamics 1 and 2 settings
INSERT Insert settings
DIRECT OUT
Direct Out settings
MIX SEND Send levels of signals sent to MIX buses
MIX ON On/off status of signals sent to MIX buses
MATRIX SEND Send levels of signals sent to MATRIX buses
MATRIX ON On/off status of signals sent to MATRIX buses
FADER Fader operations
DCA DCA group assignment
CH ON Channel on/off
MUTE Mute group assignment
On/off status of signals sent to STEREO/MONO
TO STEREO
buses
DELAY Channel delay settings
NOTE
• If you link Dynamics 1 or 2 for two or more input channels, the parameter values will be linked,
but the key-in sources are not linked and can instead be set for each channel. The behavior of
key-in signals is linked in units of 8ch*. For details about dynamics, see
page 49.
* Units of 8ch means Ch1–8, Ch9–16, Ch17–24, Ch25–32, Ch33–40, Ch41–48, Ch49–56,
Ch57–64, ST IN 1L–ST IN 4R, and ST IN 5L–ST IN 8R.
• If you turn on the EQ button or DYNAMICS 1/2 buttons, library recall operations will also be linked.
• The HA analog gain setting and the fader operation will be linked and will maintain the same
relative level difference between the channels.
• In the insert settings, the parameters for Insert 1 and Insert 2 are selected together.
65
Channel Job
"EQ and Dynamics" on
Reference Manual