Using Automixer - Yamaha QL5 Reference Manual

Inserting Automixer in channels post-fader
This section explains how to mount Automixer in a virtual rack, and insert Automixer input and
output into channels (excluding ST IN channels) post-fader (POST ON). For details on
Automixer operations, refer to the following section "Using Automixer."
STEP
1. Refer to steps 1–8 in "Virtual rack
rack 1 and set its input source and output destination.
2. Refer to "Inserting an external device into a
Automixer in post-fader (POST ON field).

Using Automixer

Channel display
The auto mix gain meter for each channel and man (yellow), auto (green), and mute (red)
settings are shown for channels 1–8 and channels 9–16.
If you select the channel 1–8 or 9–16 region, the display channel for the channel control field
will switch to 1–8 or 9–16.
(For 8ch Automixer, only channels 1–8 are shown.)
operations" on page 103 to mount Automixer in
channel" on page 18 to insert
 Channel control field
Each channel is always in man, auto, or mute mode. The indicator for the enabled channel
mode will light. To select a mode, either press the button for that mode or press the PRESET
button in the master field.
1
2
3
5
4
6
8
7
1
Level indicator
Lights green when the audio is at an optimum level for Automix.
NOTE
• If the level indicator flashes, increase the input gain.
• If the level indicator lights up red, reduce the input gain.
2
Meter indicator
There are three display modes. Pressing the meters button in the master field will switch
modes.
gain Displays the gain for Automixer.
input Displays the input level.
output Displays the output level.
NOTE
Meters should normally be set in gain mode.
3
weight
Adjusts the correlative sensitivity between input channels. When there is no input, adjust
the weight setting so that all auto mix gain meters are at about the same level.
Use the [TOUCH AND TURN] knob to change the channel weight settings by adjusting
the weight slider.
110
Graphic EQ, effects, and Premium Rack
Green
Yellow
Blue
Reference Manual