Yamaha QL5 Reference Manual page 35

 If the MIX/MATRIX bus is a stereo bus
You can link the main parameters of two adjacent odd/even-numbered MIX/MATRIX
buses. If the send-destination MIX/MATRIX bus is assigned as stereo, the left knob of the
two adjacent TO MIX/MATRIX SEND LEVEL knobs will operate as the TO MIX/MATRIX
PAN knob. (If BALANCE mode is selected in the TO STEREO/MONO window, it will
operate as a BALANCE knob).
NOTE
• For an INPUT channel (monaural), the right knob will adjust the common send level to the two
MIX/MATRIX buses, and the left knob will adjust the panning between the two MIX/MATRIX
buses. Rotating the left TO MIX/MATRIX SEND PAN knob counter-clockwise will increase the
amount of signal sent to the odd-numbered MIX/MATRIX bus, and rotating it clockwise will
increase the amount sent to the even-numbered MIX/MATRIX bus.
• For a ST IN channel (stereo), if BALANCE mode has been selected in the TO STEREO/MONO
window (8ch), the right knob adjusts the common send level for the two MIX/MATRIX buses, and
the left knob adjusts the volume balance of the left and right signals sent to the two MIX/MATRIX
buses. Rotating the left TO MIX/MATRIX SEND BAL knob counter-clockwise will increase the
amount of signal sent from the L-channel to the odd-numbered MIX/MATRIX bus, and rotating it
clockwise will increase the amount sent from the R-channel to the even-numbered MIX/MATRIX
bus. If PAN mode has been selected in the TO STEREO/MONO window (8ch), the left knob will
function as the PAN knob. The right knob will function as send level, just as in BALANCE mode.
MIX SEND/MATRIX SEND window
3 1
4
5
6
7
8
9
1
ALL PRE button
Sets the send point to PRE. (The send point is the point at which signals are sent from
all send-source channels — including the input and output channels — to the selected
send destination.) At this time, the PRE/POST button will light.
2
ALL POST button
Sets the send point to POST. (The send point is the point at which signals are sent from
all send-source channels — including the input and output channels — to the selected
send destination.) At this time, the PRE/POST button will turn off.
3
Send destination indicator
Indicates the currently-selected send destination.
4
Send destination select buttons
Select MIX/MATRIX buses as the send destination.
5
Channel select button
Selects the send-source channel that you wish to control. The current channel icon,
number, and color appear on the button, and the channel name appears below the
button.
6
PRE/POST button
Switches the send point of each send-source channel between PRE and POST. If the
button is lit, the send point is set to PRE.
NOTE
• If the PRE/POST button is on, you can also select PRE EQ (immediately before the EQ) or PRE
FADER (immediately before the fader) for each MIX/MATRIX bus. This setting is made in the BUS
SETUP window (page 189).
• The PRE/POST button is not displayed for FIXED type MIX buses.
7
SEND ON/OFF button
Switches the send of each send-source channel on or off.
35
2 3 1 2
4
5
6
7
8
9
Input channels
Reference Manual