Printing Via Tcp/Ip Ports - SEH Print Server Installation Manual

Requirements
Print Server Installation Manual

3 Printing via TCP/IP Ports

This chapter describes the installation of your print
server for printing via TCP/IP ports in SINIX SPOOL V4.x
or X print systems.
Some UNIX systems support the linkage of network printers by
means of direct TCP/IP connection. Print data can be transferred
from the spooler to the print server via TCP/IP ports.
If this is the case, you must configure the port number. To do this,
you must install a printer port and enter the port number. Refer to
the print server documentation for more information on TCP/IP
ports.
When installing the print server in SINIX SPOOL V4.x or X print
systems, you must install a server, a supervisor, and a printer.
The print server is known to the network via its IP address, see:
13.
The host name has been assigned to the IP address, see:
The print server is connected and the printer is turned on.
Proceed as follows:
1. Install a new server in the spooler:
Syntax: xpadd -srv <server name> -sp <time control>
Example: xpadd -srv server1 -sp PRIORITY2
2. Install a new supervisor in the spooler:
Syntax: xpadd -spv <supervisor> -se <server name>
Example: xpadd -spv admin -se server1
3. Add a new printer:
Syntax:
xpadd -dev <printer name>
-da <host name> <TCP/IP port>
-su <supervisor> -co <connection>
-aa -pc <printer control language>
Example:
xpadd -dev my_printer
Printing via TCP/IP Ports
12.
29