Requirements
Print Server Installation Manual
Saving the IP Address via the IP Wizard (InterCon-NetTool)
You can easily enter the desired IP address and save it in the print
server using the IP Wizard of the InterCon-NetTool. The IP Wizard
helps you to configure the TCP/IP parameters, e.g. the IP address.
The InterCon-NetTool is installed on the client.
By means of the InterCon-NetTool you can scan the network via
Multicast, see: Print Server User Manual.
The router in the network forwards multicast requests.
Proceed as follows:
1. Start the InterCon-NetTool.
2. Select the print server from the print server list.
The print server is displayed in the print server list under 'ZeroConf' with an IP
address from the address range 169.254.0.0/16, which is reserved for ZeroConf.
3. Select Installation – IP Wizard from the menu bar.
The IP Wizard is started.
4. Follow the instructions of the Wizard.
The settings are saved.
Fig. 1: InterCon-NetTool - IP Wizard
Information
16
Need help?
Do you have a question about the Print Server and is the answer not in the manual?