Figure 2-3 Inserting The Server With Mounting Brackets Into The Slide Rails - Sun Microsystems Sun Fire V210 Installation Manual

To Install the Server Into the Slide Rail
▼
Assemblies
Caution – This procedure requires a minimum of two people because of the weight
of the server. Attempting this procedure alone could result in equipment damage or
personal injury.
1. Push the slide rails into the slide rail assemblies as far as possible.
2. Raise the server so that the rear ends of the mounting brackets are aligned with
the slide rail assemblies that are mounted in the equipment rack (see
3. Insert the mounting brackets into the slide rails, then push the server into the rack
until the mounting brackets encounter the slide rail stops (approximately 12 in or
30 cm).
Inserting the Server With Mounting Brackets Into the Slide Rails
FIGURE 2-3
FIGURE 2-3
Chapter 2 Installing the Hardware
).
9