Installing The Slide Rails; To Disassemble The Slide Rails - Sun Microsystems Sun Fire V210 Installation Manual

Perform the procedures in this chapter, in the order they are listed, to install your
server into a four-post rack using the orderable slide rail option. This set of slide
rails has been designed to work with both the Sun Fire V210 and Sun Fire V240
servers. These slide rails are compatible with a wide range of equipment racks that
meet the following standards:
Four-post structure (mounting at both front and rear). Two-post racks are not
■
compatible.
Rack horizontal opening and unit vertical pitch conforming to ANSI/EIA 310-D-
■
1992 or IEC 60927 standards.
Distance between front and rear mounting planes between 610 mm and 915 mm
■
(24 inches to 36 inches).
Clearance depth (to front cabinet door) in front of front rackmounting plane at
■
least 25.4 mm (1 inch).
Clearance depth (to rear cabinet door) behind front rackmounting plane at least
■
800 mm (31.5 inches), or 700 mm (27.5 inches), without cable management arm.
Clearance width (between structural supports and cable troughs) between front
■
and back mounting planes at least 456 mm (18 inches).
Note – Although the Sun Fire V210 server is pictured in the illustrations, these
procedures also apply to the Sun Fire V240 server.
Caution – Always load equipment into a rack from the bottom up so that it will not
become top heavy and tip over. Deploy the anti-tilt bar to prevent the rack from
tipping during equipment installation.

Installing the Slide Rails

The procedures in this section contain instructions to install the slide rail assemblies
to the rack and the server chassis, with mounting brackets, into the slide rail
assemblies that are mounted to the rack.
▼

To Disassemble the Slide Rails

1. Unpack the slide rails.
6 Sun Fire V210 and V240 Servers Installation Guide • November 2005