To Install The Mounting Brackets Onto The Server; To Attach The Slide Rail Assemblies To The Rack; To Install The Server Into The Slide Rail Assemblies; Figure 2-2 Slide Rail Assembly Mounting To Rack Post - Sun Microsystems Sun Fire V210 Installation Manual

To Install the Mounting Brackets Onto the
▼
Server
1. Position a mounting bracket against the chassis so that the slide rail lock is at the
server front and the three keyed openings on the mounting bracket are aligned
with the three screw holes on the side of the chassis.
2. Attach the slide rail onto the server with the supplied screws.
3. Repeat Steps 1 and 2 to install the other slide rail.

To Attach the slide rail Assemblies to the Rack

▼
1. Position a slide rail assembly in your rack so that the brackets at each end of the
slide rail assembly are on the outside of the front and rear rack posts (as depicted
in
FIGURE 2-2
2. Attach the slide rail assembly to the rack posts.
The method used to attach the slide rails varies depending on the type of rack:
If your rack has threaded mounting holes in the rack posts, determine whether
■
the threads are metric or standard, then insert the correct mounting screws
through the slide rail brackets and into the threaded holes.
If your rack does not have threaded mounting holes, insert the mounting screws
■
through both the slide rail brackets and rack posts, then secure them with the
caged nuts.
FIGURE 2-2
3. Repeat for the remaining slide rail assembly.
8 Sun Fire V210 and V240 Servers Installation Guide • November 2005
).
Slide Rail Assembly Mounting to Rack Post