Draytek Vigor2110 Series User Manual page 53

nd
2 IP Address
nd
2 Subnet Mask
nd
2 DHCP Server
RIP Protocol Control
Vigor2110 Series User's Guide
Type in secondary IP address for connecting to a subnet.
(Default: 192.168.2.1/ 24)
An address code that determines the size of the network.
(Default: 255.255.255.0/ 24)
You can configure the router to serve as a DHCP server for the 2nd
subnet.
Start IP Address: Enter a value of the IP address pool for the DHCP
server to start with when issuing IP addresses. If the 2nd IP address
of your router is 220.135.240.1, the starting IP address must be
220.135.240.2 or greater, but smaller than 220.135.240.254.
IP Pool Counts: Enter the number of IP addresses in the pool. The
maximum is 10. For example, if you type 3 and the 2nd IP address of
your router is 220.135.240.1, the range of IP address by the DHCP
server will be from 220.135.240.2 to 220.135.240.11.
MAC Address: Enter the MAC Address of the host one by one and
click Add to create a list of hosts to be assigned, deleted or edited IP
address from above pool. Set a list of MAC Address for 2
server will help router to assign the correct IP address of the correct
subnet to the correct host. So those hosts in 2
IP address belonging to 1
Disable deactivates the RIP protocol. It will lead to a stoppage of the
exchange of routing information between routers. (Default)
1st Subnet - Select the router to change the RIP information of the
1st subnet with neighboring routers.
2nd Subnet - Select the router to change the RIP information of the
2nd subnet with neighboring routers.
43
nd
subnet won't get an
st
subnet.
nd
DHCP