Replacing The Lcd Assembly - Gateway Convertible Service Manual

Replacing the LCD assembly

Tools you need to complete this task:
v
Screws removed during this task:
To replace the LCD assembly:
1
2
3
4
5
6
40
Replacing convertible notebook components
Flat-blade driver
Phillips #0 screwdriver
4 or 6 black 2.5*8.0 (LCD
hinge to notebook)
Complete the steps in "Preparing the convertible notebook" on page
If the convertible notebook has wireless networking built in, unplug the wireless antennas
by following the steps in "Replacing the IEEE 802.11 wireless card" on page
Remove the screws on the bottom that secure the LCD panel hinge to the chassis.
Important
The number of screws varies by convertible notebook model.
Screw
Turn the convertible notebook over so the top is facing up.
Remove the hinge covers by following the steps in
Open the LCD panel to the fully open position.
Caution
Be careful not to use too much force when opening the LCD panel.
- OR -
Screw
Screw Screw
"Replacing the hinge covers" on page
Scribe or non-marring tool
5.
16.
26.