Replacing The Lcd Panel Assembly - Gateway M675 Service Manual

Replacing the LCD panel assembly

Tools you need to complete this task:
Screws removed during this task:
1 chrome 2.5 × 2.5 mm
Torx
(mini-PCI card)
To replace the LCD panel assembly:
1
Follow the instructions under
2
Disconnect the AC adapter and modem and network cables, then prepare the
notebook by following the instructions in
3
Turn the notebook over so the bottom is facing up.
4
Remove the battery by following the instructions in
page 7.
5
Remove the hard drive by following the instructions in
on page 9.
40
Flat-blade driver
Phillips #0 screwdriver
2 chrome 2.5 × 2.5 mm
(LCD plug)
- OR -
5 chrome 2.5 × 2.5 mm
(keyboard)
6 chrome 2.5 × 2.5 mm
(LCD panel assembly)
"Preventing static electricity discharge" on page
"Preparing the notebook" on page
www.gateway.com
Scribe or non-marring tool
Torx T8 screwdriver
4 chrome 2.5 × 2.5 mm
(hinge cover)
"Removing the battery" on
"Replacing the hard drive kit"
5.
6.