Replacing The Fingerprint Reader - Gateway Convertible Service Manual

Replacing the fingerprint reader

Tools you need to complete this task:
v
Screws removed during this task:
To replace the fingerprint reader:
1
2
3
4
5
6
7
8
9
www.gateway.com
Flat-blade driver
Phillips #0 screwdriver
1 black 2.5*8.0 (Optional
bay module security
screw)
4 or 6 black 2.5*8.0 (LCD
hinge to notebook)
3 chrome 2.0-0.4*2.0
(palm rest-modular
drive bay)
Complete the steps in "Preparing the convertible notebook" on page
Remove the bay module by following the steps in
If the convertible notebook has wireless networking built in, unplug the wireless antennas
by following the steps in "Replacing the IEEE 802.11 wireless card" on page
Remove the hard drive by following the steps in
Remove the keyboard cover by following the steps in
page 27.
Remove the keyboard by following the steps in
Remove the LCD assembly by following the steps in
Remove the palm rest by following the steps in
Turn the palm rest over so the back side is facing up.
- OR -
1 chrome 2.5*5.0 (Hard
drive)
14-16 black 2.5*8.0
(palm rest-bottom)
1 black 2.5*8.0 (palm
rest-top)
"Replacing a bay module" on page
"Replacing the hard drive" on page
"Replacing the keyboard cover" on
"Replacing the keyboard" on page
"Replacing the LCD assembly" on page
"Replacing the palm rest" on page
Scribe or non-marring tool
2 black 2.5*8.0
(Keyboard)
2 chrome 2.0*5.0
(palm rest-hard drive
bay)
2 chrome 2.0*3.0
(Fingerprint reader)
5.
7.
16.
21.
28.
50.
53
40.