Gateway Convertible Service Manual page 49

11
Remove the four screws that secure the old hinge to the LCD panel assembly.
Screws
12
Replace the new hinge onto the LCD panel assembly.
13
Replace the screws removed in
14
Feed the wiring back into the hinge.
Tip
Start by feeding the wire that has the largest connector into the hinge. Then
proceed to the wire that has the next smallest connector and so on.
15
Replace the screws that were removed in
16
Press the LCD panel front and back together. Press the two halves together in several places
until they click in place. You should find no loose spots or spots where the two halves do
not meet.
17
Replace the LCD panel assembly screws removed in
18
Replace the inserts removed in
Caution
The larger rubber inserts go across the top of the panel.
19
Replace the LCD assembly by following the steps in
20
Replace the keyboard cover by following the steps in
page 27.
21
Replace the hinge covers by following the steps in
22
Reconnect the antenna wires to the wireless card by following the steps in
IEEE 802.11 wireless card" on page
23
Replace the wireless bay cover by following the steps in
card" on page 16.
www.gateway.com
Step 11.
Step 8, then reconnect the cable.
Step 4.
16.
Screws
Step 5.
"Replacing the LCD assembly" on page
"Replacing the keyboard cover" on
"Replacing the hinge covers" on page
"Replacing the IEEE 802.11 wireless
40.
26.
"Replacing the
45