Upgrade By Usb; Remove Usb Device Safely - Strong SRT 8113 User Manual

Input the correct password using the 0~9 buttons (dEfAulT PIn: 1234). A confirmation window
is displayed.
Select Yes to return to factory settings. Select No to cancel.
Press EXIT to leave.
7.5.3 s/W upgrade by oTA
This receiver is equipped with a manual and automatic OTA "Over-The-Air" software upgrade mechanism.
This menu allows you to manually upgrade the Over-The-Air update if the automatic update
mechanism does not function. It might not be available in your region. Please visit our website www.
strong.tv or contact your local service hotline for more information about this option.
noTE:
If the receiver found new software it will show a message the next time you switch the receiver to ON
and you can confirm to load. After an update the receiver restarts automatically.
WARnIng:

7.5.4 upgrade by usb

This feature allows you to upgrade receiver software via the USB port. When new software is available
for your receiver, it can be downloaded from our website www.strong.tv.
Place the software file (unzipped) in the root directory of your USB storage device (HDD, memory
stick etc.) and insert this device into the USB port of the receiver.
Select Upgrade by USB from the Tools menu and press ok to proceed.
The upgrade menu will now be displayed.
Use p q to select Upgrade Mode and choose option Allcode.
Use p q to select Upgrade File and choose the file containing the new software.
Once all settings are made, move the highlight to Start and press ok to start the upgrade process.
After a few seconds, the receiver asks: "Are you sure to burn flash?". Select Yes to finalize the upgrade
or No to quit without upgrading.
noTE:
WARnIng:

7.5.5 Remove usb device safely

Select Remove USB device safely from the tools menu and press ok. The receiver will display a
message indicating that you can safely remove your storage device from the receiver.
18
When you switch to Standby the OTA "Over-The-Air" software upgrade
mechanism will check if new software is available. During this process the
LED on front will light green. This can take a couple minutes!
During the upgrade process NEVER disconnect the receiver from the mains
or switch off the power! Doing so might damage your receiver and will void
warranty!
If, after a software upgrade, the receiver should behave in an unexpected
way, please perform a factory reset as well. See chapter 7.5.2. After an update
the receiver restarts automatically.
During the upgrade process NEVER disconnect the receiver from the mains
or switch off the power! Doing so might damage your receiver and will void
warranty!
PART 1 • English