System Setup - Strong SRT 8113 User Manual

PART 1 • English
7.3.4.3 Rf loop In standby
Set this option to On if you connect a second receiver or TV to the loop out (ANT OUT) of this
receiver. This will allow passing antenna signals if the receiver is in standby mode. To reduce power
consumption is default set to Off.
noTE:

7.4 system setup

This menu allows you to manage the system settings of your receiver. It consists of the following
sub-menus: Language, TV System, Display Setting, Local Time Setting, Timer Setting, Parental Lock, OSD
Setting, Favourite List Rename and Multiview Setting.
Press p q to highlight the menu of choice and press ok advance to the next screen. Use p q to
move the highlight to the setting of choice. Values can be changed with t u. Press EXIT to leave.
7.4.1 language
This menu allows you to set up your language preferences.
Language:
First Audio:
Second Audio:
Teletext:
7.4.2 Tv system
Use this menu to match your receiver to your TV set. The following settings are available:
Video Resolution:
Aspect Mode:
Video Out:
RF System:
RF Channel:
The Antenna Power supplies (5 Volt) switch off in standby mode. If you are
using an active antenna then the option RF Loop in Standby is not usable.
Use t u to select the language for the On Screen Display.
Use t u to select Audio language.
Use t u to select a language that will be played when the language selected
at First Audio isn't available.
Use t u to select the preferred teletext language (when available.)
Use this option to select the video resolution of your TV screen. The options
are: By Source (automatic detection of video resolution offered to the
receiver), By Native TV (automatic detection of maximal resolution of TV
screen) and manual selections 480i, 576i up to 1080p. Please use a setting that
matches your TV's specifications. After a selection is made, you will be asked
to confirm. Selection above 576i is only applicable on HDMI output.
Use this option to select the aspect ratio of your TV and the preferred
conversion method. The options are: Auto (automatic detection of aspect
ratio), 4:3 Panscan (Displays 16:9 widescreen broadcasts full screen on your
4:3 TV), 4:3 letterbox (black bars on top and under the picture on a 4:3 TV) and
16:9 (use this setting for 16:9 TV sets).
Use this option to select which video quality you like to have on the TV SCART
output. Select CVBS or RGB for best quality. If you using a HDMI cable then
select CVBS. This selection allow you to select behind Video Resolution also the
high resolutions up to 1080p.
When using the TO TV connector on the rear panel (the built-in RF
modulator), you can select here your TV set's analogue reception system.
Default is PAL-BG.
Set the RF channel of the modulator. Default is channel 38.
15