Ptz; Ptz Control Panel - EverFocus ECOR 264x1-16 Instruction Manual

3.6 PTZ

3.6.1

PTZ control panel

If the connected camera is defined as a PTZ device (Speed Dome, PTZ head with RS-485 receiver), the
PTZ control panel is shown at left side after clicking on
Required settings: 1. PTZ is enabled and RS-485 address is entered in CAMERA > BASIC SETTING.
2. RS-485 parameter are adjusted in SYSTEM > I/O CONTROL
Go to Preset Position
Save Preset Position
Delete Preset Position
Start Preset Tour
Start Pattern
Start Auto-Pan
Open Setup Menu
Enter in Speed Dome OSD
ESC / Cancel in Speed Dome OSD
Pan / Tilt direction keys
Zoom in (+), Zoom out (-)
Focus far (+), Focus near (-)
Iris open (+), Iris close (-)
Input field for preset, tour and pattern numbers
Number buttons
Clear numeric input
Start (for preset, tour, pattern)
Save preset position
Delete preset position
Auto-Pan
Preset position
Preset Tour
Pattern
PRESET > [number] > GO
PRESET > [number] > SET
PRESET > [number] > DELETE
TOUR > [number] > GO
PATTERN
Note: The PATTERN commands vary depending on dome model
/manufacturer. Please consult documentation of the speed dome for details.
AUTO-PAN
PRESET > [95] > SET
I+ ((iris open)
I- (Iris close)
button.
25