EverFocus ECOR 264x1-16 Instruction Manual page 65

Record Stop:
Log Check box to record events in the log.
Buzzer Check box to enable buzzer if the recording process is terminated.
Email Notify Check box to enable email notification when the recording process is terminated.
Email operation requires that valid email settings have been entered in the Network
Setting/Email setup screen.
Network Alarm Check box to send out a network alarm to client PC. (requires PowerCon software and
setting up Alarm Server in Network Setup menu)
Alarm Output Selection of relay output as event reaction "NONE" (not active), "1" ~ "4" for the relay
(in 4 channel version is only 1 relay available).
Note: In this operation mode the relay is powered, if record stops. If record is stopped
Output Type Output action when alarm is triggered.
Timeout The amount of time the buzzer sounds when the recording process is terminated.
Duration Duration selectable from 1 to 150 seconds.
Figure 4-18 Alarm & Event Menu – Event – Record Stop
due to power loss, there will be no reaction.
If relay reaction is needed also in case of power loss, please use the
"RECORD STATUS RELAY OUTPUT" in RECORD menu (chapter 4.4.1
RECORD).
Timeout: Alarm output lasts for the set time duration.
Permanent: Alarm will be continuously active until user presses "Enter" key.
Transparent: Alarm output remains active until event ends.
Trans+Timeout: Alarm output continues until event ends, then lasts for the set time
duration.
59