Table of Contents
Advertisement
Alarm Output
Output Type
Timeout Duration
Edit Motion Grid
depend on DVR setting)
Selection of relay output as event reaction "NONE" (not active), "1" ~ "4" for the relay
(in 4 channel version is only 1 relay available).
Output action when motion is triggered.
Timeout
Alarm output lasts for the set time duration.
Permanent
Alarm will remain active until user presses the "Enter" key or
resets the alarm remotely.
Transparent
Alarm output remains as long as the alarm input is active.
Trans+Timeout Alarm output continues until event ends, then continues for the
set time duration.
Time duration selectable from 1 to 150 seconds.
Press this button to edit the motion grid (See
Motion Grid
).
Setting
Sensitivity Set the threshold value for sensitivity within the grids. Select from 1
(lowest) to 10 (highest).
Min Area To avoid false detections by small objects this value defines how many
grids have to be exceed threshold before generating a motion event. Select a value
between 1 (default) to 5 grids.
Preview Preview the motion grid.
Set All Press this button to select the entire area.
Clear All Press this button to clear all the grids selected.
Save & Back Press this button to save the motion grid setting and return to motion
setting menu.
Cancel Press this button to cancel all changes and returns to the motion setting
menu.
How to select motion grid by mouse
1) Select lower-right grid.
2) Select upper-left grid.
3) The area between upper-left and lower-right grid will be selected.
How to select motion grid by front panel
1) Press Enter key to enter motion grid.
2) Use arrow keys to select one corner of desired area
3) Press Enter key at the starting point.
4) Use arrow keys to select motion area.
5) Press Enter key twice at the end point, and the area will be selected.
44
Figure 4-5 Camera Menu –
Advertisement
Table of Contents
