Table of Contents
Advertisement
2. Click again to confirm, then a new sequence number (for the new section) will show on this block and
current and all following blocks will turn to gray. This means this new gray timezone has a new
record mode (No record).
Change the section to different mode (with different color) by clicking on the first (numbered) block
of each section. The color switches from gray -> orange -> blue, every time user clicks the first
block of a section.
3. Repeat clicking on the first block (indicated by a sequence number on it) of any timezone, this timezone
will change from one color to another, which means switching the record mode. The color switch
sequence is gray->orange->blue.
Schedule Setting from front panel
1. Enter schedule setting mode: press "Enter" button to enter schedule setting mode. At this time, the
whole editing area at right-down side will be highlighted within a blue frame. See below image.
2. Enter camera selection mode: Use Up/Down arrow key to switch to Camera selection mode. When
Camera selection mode is selected, all cameras will be highlighted in a blue frame. See below
image.
3. Selecting camera: Use Right/Left arrow key to select desired camera to configure. Selected camera
number will be highlighted by a blue frame. See above image.
4. Enter time bar editing mode: Use Up/Down arrow key to switch to time bar editing mode. When this
mode is selected, all 9 time bars will be highlighted within a blue frame.
5. Select desired time bar for setting: press Enter button, the first time bar will be selected for setting
and highlighted in a red frame. See below image. Use Up/Down arrow key to desired time bar for
setting.
64
Advertisement
Table of Contents
