Table of Contents
Advertisement
Default: 9600
Data Bit
Data bit used for transmission, select 7 or 8
Default: 8
Stop Bit
Stop bit used for transmission, select 1 or 2
Default: 1
Parity
Parity setting for RS-485 transmission, select NONE, ODD or EVEN
Default: NONE
CONTROL
IR Remote ID
Receiver ID for IR - remote control. Select 1~4.
One remote control can be used to operate up to 4 DVRs. The DVR to be addressed is
selected by pressing the key corresponding to its ID number on the remote control.
4.10.5
Misc.
Firmware
Current Firmware Version Displays the current version.
Firmware Upgrade
Configurations
Load Factory Default
Figure 4-41 System Menu – Firmware & Misc.
Press "Upgrade" to upgrade the firmware.
NOTE To perform a Firmware Upgrade, you will need to connect a
USB flash device with the latest version of the firmware. Do not
disconnect the USB device or turn off the power to the unit during
the upgrade; this can cause the system to fail to recover, requiring
factory service to repair.
Click "Load" to restore all menu settings to the default values. User
Account, Network Setting, and Time are not affected.
87
Advertisement
Table of Contents
