Table of Contents
Advertisement
Network Loss:
Log
Check box to record events in the log.
Buzzer
Check box to enable buzzer when network is lost.
Alarm Output
Selection of relay output as event reaction "NONE" (not active), "1" ~ "4" for the relay (in
4 channel version is only 1 relay available).
Output Type
Output action when alarm is triggered.
Timeout:
Permanent:
Transparent: Alarm output remains active until event ends.
Trans+Timeout: Alarm output continues until event ends, then lasts for the set time
Timeout
The amount of time the buzzer sounds when DVR stops recording. Duration selectable
Duration
from 1 to 150 seconds.
NOTE: This function only checks the physical connection (link) to the network. Any network behavior that
blocks data connectivity (blocked ports, IP addressing errors, etc.) is not detected by this function.
Figure 4-19 Alarm & Event Menu – Event – Network Loss
Alarm output lasts for the set time duration.
Alarm will be continuously active until user presses "Enter" key.
duration.
60
Advertisement
Table of Contents
