Table of Contents
Advertisement
4.3.4
Video Loss
Camera
Enable
Log
Pre-alarm Record
Buzzer
Email Notify
Network Alarm
Alarm Output
Output Type
Figure 4-6 Camera Menu – Video Loss
Select the camera you wish to adjust, "Title" will change to the title name of the
selected camera.
Check box to enable Video Loss detection.
Check box to record video loss events in the log.
Check box to start copying recorded video to the hard disk from several moments
before the video loss. (Pre-alarm recording rate will follow "Normal" frame rate
setting)
Check box to enable buzzer when a video loss event occurs.
Check box to enable email notification when a video loss event occurs. Email
operation requires that valid email settings have been entered in the Network
Setting/Email setup screen.
Check box to send out a network alarm to client PC when video loss occurs.
(requires PowerCon software and proper settings for the Alarm Server in the
Network Setup menu)
Selection of relay output as event reaction "NONE" (not active), "1" ~ "4" for the
relais (in 4 channel version is only 1 relay available).
Output action when alarm is triggered.
Timeout:
Alarm output lasts for the set time duration.
Permanent:
Alarm will remain active until user presses "Enter" key on front
panel.
Transparent: Alarm output continues as long as there is a video loss.
Trans+Timeout: Alarm output continues until event ends, then continues for the
set time duration.
46
Advertisement
Table of Contents
