Button; Set Button; Back Button; Lcd Display - Brother HL-6050 Service Manual

CHAPTER 2 INSTALLATION AND BASIC OPERATION
4.2.4 + & - button
If you press the + or – button when the printer is in the on-line (READY), it goes off-line and
the LCD displays the menu.
(1) To move through menus on the LCD
If you press the + or – button when the printer is in the on-line (READY), it goes off-line
and the LCD displays the current mode.
You can go to other menus by pressing the + or – button. Pressing the + or – button
allows you to move forward or backward through the menus and settings on the display.
Press or keep pressing the button until you see the setting you want.
(2) To enter numbers
There are two ways to enter numbers. You can press the + or – button to move up or
down one number at a time, or you can hold down the + or – button to move faster. When
you see the number you want, press the Set button.
4.2.5

Set button

If you press the Set button when the printer is in the on-line (READY), it goes off-line and the
LCD goes to the menu.
Pressing the Set button allows you to choose the displayed menu or option. After changing a
setting, an asterisk appears briefly on the right-hand side of the message.
4.2.6

Back button

If you press the Back button when the printer is in the on-line (READY), it goes off-line and
the LCD goes to the menu.
Pressing the Back button allows you to return to the previous level from the current menu
level. The Back button also allows you to choose the previous digit while setting numbers.
When you select a setting and it does not have an asterisk (Set button was not pressed), the
Back button allows you to return to the previous menu level with the original setting
unchanged.
NOTE:
When you press the Set button to choose a setting, an asterisk appears briefly at the end of
the display. Since the asterisk shows what you have chosen, you can easily see the current
setting as you look through the display.
4.3

LCD Display

The display shows the current printer status. When you use the control panel switches, the
display will change.
When you take the printer off-line, the display changes to show the selected emulation.
If any problems occur, the display shows the corresponding operator call, error, or service call
message to prompt you to take an action. For more information about these messages, see
CHAPTER 6 'TROUBLESHOOTING'.
2-14