Paper Problems; Paper Loading Problems - Brother HL-6050 Service Manual

3.

PAPER PROBLEMS

When any paper related problem occurs, ensure that the paper used meets the recommended
paper specifications referring to
3.1

Paper Loading Problems

Problem
The printer does not
load paper.
The printer does not
load paper from the
multi-purpose tray.
The printer does not
load envelopes.
Envelope is creased
after it is printed.
There is a paper jam.
The printer feeds
multiple pages.
The printer does not
print to the face-down
output tray.
The printed pages are
curled, so the face-down
output tray can not hold
the maximum number of
sheets.
subsection 3.5 'Paper' in CHAPTER
(1) If paper is in the paper tray, make sure it is straight. If the
paper is curled, you should straighten it before printing.
Sometimes it is helpful to remove the paper, turn the stack
over, and then put it back in the paper tray.
(2) Reduce the amount of paper in the paper tray, and then try
again.
(3) Make sure that manual feed mode is not set in the printer
driver.
(4) If there is paper dust on the separation roller, wipe it off with a
moistened soft cloth.
(5) The pickup roller or separation pad needs to be replaced.
(1) Fan the paper well and put it back in firmly.
(2) Make sure you have chosen the manual feed mode in the
printer driver.
The printer can load envelopes from the multi-purpose tray. You
must set up your application software to print on the size of
envelopes you are using. This is usually done in the page setup
or document setup menu of the software. Refer to the software
application manual.
Open the back output tray, and push down the blue tabs that are
at the left-hand and right-hand sides of the back of the printer.
(1) Clear the jammed paper. Refer to
chapter.
(2) If there is paper dust on the separation roller, wipe it off with a
moistened soft cloth.
(3) The pickup roller or separation pad needs to be replaced.
The pickup roller or separation pad needs to be replaced.
Close the back output tray.
(1) Turn over the paper in the paper tray.
(2) Change the printer driver setting in Media Type to a thicker
seting.
6-11
HL-6050/6050D/650DN SERVICE MANUAL
1.
Remedy
3.2 Paper jams in this